Starlink Tips

Dishy access via web or app when using a 3rd party router

Ensure your router can support a static route on the wan side
Create a static route on the wan interface:
- Network destination: 192.168.100.0
- Subnet Mask: 255.255.255.0
- Gateway: 192.168.100.1
- Interface: WAN

Go to http://dishy.starlink.com in edge - if that fails go to http://192.168.100.1. Note HTTP not HTTPS

Booting - Starting up. keep waiting
Searching - Looking for satellites
Disconnected - Not connected
Poor Cable Connection
Online - Connected

When packing up, if you run into issues ‘stowing’ dishy (putting it back into position for packing away). You can try the following:

Close the web browser and try the steps above ‘Pack up’ again
Manually trigger automatic stowing
1. Leaving Dishy plugged in to at least power, remove dishy from its base
2. Place dishy upside down on a flat clean surface that won’t scratch or damage dishy
3. After a period of time (either 1 minute or 10 minutes) dishy should automatically stow itself
4. Turn the power off
Don’t stow dishy
1. Turn the power off
2. Pack Dishy separately, safely in the unstowed position

Firmware Updates are usually installed between 1 AM and 4 AM in the timezone where the device is located by GPS.
It is commonly 3:00 AM +/- 30 minutes https://starlink-enterprise-guide.readme.io/docs/software-updates